Oil Spill in Bioremediation Laboratory

Introduction

Water and oil do not mix; instead, oil congeals into thick sludge. According to Tang et al. (2019), oil spills can harm the environment and marine life. When oil is released into the ocean, it can poison local marine creatures and harm their immunological, reproductive, and respiratory systems. The goal of the laboratory is to simulate the process of bioremediation, which involves using living organisms to remove environmental contaminants from a contaminated area. The lab’s objective is to explore the potential for bioremediation to reduce ocean pollution.

Tetrazolium will not affect the color of the liquid in tube 1 because it contains a large volume of water and a relatively small amount of oil and tetrazolium. In tube 2, adding a microbial solution to the tetrazolium, water, and oil may result in an unclear chemical reaction. Tube 3, which contains a mixture of water and oil, will show the oil separating from the water and the bulk of the liquid remaining clear, as oil and water do not mix. In tube 4, a microbial solution in the mixture of water, oil, and a microbial solution will cause the oil to be broken down, resulting in a color change. If tube 5, which contains a mixture of water, oil, and a microbial suspension, is kept in a warmer temperature setting, the oil breakdown by the microbial solution will occur more quickly. In contrast, if the same mixture is kept at a cooler temperature in tube 6, the breakdown process will proceed more slowly.

Results

Data Table 1: Tubes 1 and 2 Observations

Day Tube 1 Tube 2
0
(Initial setup)
The transparent liquid is developing an oil ring at the top with some bubbles. The liquid has a hazy yellow tint, with an oil ring developing on the surface.
1 No change. Less hazy but still yellow, the liquid has an oil ring at the top, and part of the microbial solution has settled at the tube’s bottom.
2 No change. The liquid has less cloudiness than Day 1’s and still has an oil ring on top, a yellow tint color, and a settled microbial solution at the bottom.
3 No change. The liquid still has a yellow tint and is hazy and clear. Precipitate of microbial and the oil ring at the top is still seen.

Data Table 2: Tubes 3 and 4 Observations

Day Tube 3 Tube 4
0
(Initial setup)
The liquid is transparent and has an oil ring growing on the surface. Similar to tube 3.
1 No change. Microbial solution precipitated at the bottom, and the liquid is less hazy. An oil ring has also developed on top of the liquid.
2 No change. No change.
3 No change. No change.

Data Table 3: Tubes 5 and 6 Observations

Day Tube 5 Tube 6
0
(Initial setup)
An oil ring is developing at the top of the liquid, which is quite hazy and has a yellow tint. Similar to tube 5.
1 Less hazy, with a yellow tint, an oil ring has developed at the top, and part of the microbial solution has settled at the tube’s bottom. The liquid is still quite hazy and has a yellow tint to it. An oil ring has developed on top, and part of the microbiological solution has settled at the bottom of the tub.
2 No change. No change.
3 The liquid is quite hazy, with a slight pink and yellow tint, an oil ring at the top, and a microbial solution that has congealed at the bottom of the tube. A faint pink liquid is still highly hazy due to the oil ring at the top and the microbial solution accumulated at the tube’s bottom.

Photographs

Initial Setup
Figure 1: Initial Setup
Day 1
Figure 2: Day 1
Day 2
Figure 3: Day 2
Day 3
Figure 4: Day 3

Analysis

Tube 1 contained 1 mL of tetrazolium, 4 mL of distilled water, and ten drops of oil. The hypothesis was that the high concentration of water would prevent any color change. The results showed that the liquid remained clear, supporting the hypothesis. Tube 2 contained 1 mL of tetrazolium, 2 mL of distilled water, ten drops of oil, and 2 mL of microbial solution. The hypothesis was that the addition of the microbial solution would cause the color to shift. The results showed that the liquid became turbid with a yellow tinge, supporting the hypothesis.

Tube 3 contained a mixture of water and oil. The hypothesis was that the oil would separate from the water and the liquid would remain clear. The results showed that the oil did not mix with the water, and the liquid remained clear, supporting the hypothesis. Tube 4 was at a normal temperature, tube five was at a higher temperature, and tube six was at a lower temperature. The results showed that the higher temperature in tube 5 led to a faster breakdown of the microorganisms, resulting in a less murky liquid. The lower temperature in tube 6 slowed down the breakdown of the microorganisms, resulting in the liquid remaining the darkest by day 4.

Conclusion

The lab had a lot of insight into oil spills directly related to the real world. Bioremediation is a cost-effective, effective, and ecologically benign method for cleaning up both on- and offshore oil spills (Nadhirawaty & Titah, 2019). The Exxon Valdez and Deepwater Horizon oil disasters both successfully used microorganisms to digest petroleum hydrocarbons, reducing environmental damage. Microorganisms were deployed in both oil disasters to digest petroleum hydrocarbons, lessening the environmental damage.

This lab had fewer challenges to overcome since it was quite straightforward. It was challenging to monitor over several days when the drinks appeared almost identical since it made it difficult to describe any distinctions. There are drawbacks that bioremediation has in terms of dealing with oil spills. These are approached by creating a new lab experiment involving adding common household substances individually into several test tubes.

References

Nadhirawaty, R., & Titah, H. S. (2019). Simultaneous Bioaugmentation and Biostimulation to Remediate Soil Contaminated by Ship Dismantling in Bangkalan District, Indonesia. Journal of Health and Pollution, 9(24). Web.

Tang, D., Sun, J., Zhou, L., Wang, S., Singh, R. P., & Pan, G. (2019). Ecological response of phytoplankton to the oil spills in the oceans. Geomatics, Natural Hazards and Risk, 10(1), 853–872. Web.

Cite this paper

Select style

Reference

StudyCorgi. (2024, January 9). Oil Spill in Bioremediation Laboratory. https://studycorgi.com/oil-spill-in-bioremediation-laboratory/

Work Cited

"Oil Spill in Bioremediation Laboratory." StudyCorgi, 9 Jan. 2024, studycorgi.com/oil-spill-in-bioremediation-laboratory/.

* Hyperlink the URL after pasting it to your document

References

StudyCorgi. (2024) 'Oil Spill in Bioremediation Laboratory'. 9 January.

1. StudyCorgi. "Oil Spill in Bioremediation Laboratory." January 9, 2024. https://studycorgi.com/oil-spill-in-bioremediation-laboratory/.


Bibliography


StudyCorgi. "Oil Spill in Bioremediation Laboratory." January 9, 2024. https://studycorgi.com/oil-spill-in-bioremediation-laboratory/.

References

StudyCorgi. 2024. "Oil Spill in Bioremediation Laboratory." January 9, 2024. https://studycorgi.com/oil-spill-in-bioremediation-laboratory/.

This paper, “Oil Spill in Bioremediation Laboratory”, was written and voluntary submitted to our free essay database by a straight-A student. Please ensure you properly reference the paper if you're using it to write your assignment.

Before publication, the StudyCorgi editorial team proofread and checked the paper to make sure it meets the highest standards in terms of grammar, punctuation, style, fact accuracy, copyright issues, and inclusive language. Last updated: .

If you are the author of this paper and no longer wish to have it published on StudyCorgi, request the removal. Please use the “Donate your paper” form to submit an essay.